Mount the switch with the hole cutting dimensions shown in the dimensions.
Please contact us if you are considering using a panel of other than the recommended size and shape.
Refer to the diagram above, "soldering position," for details on the position where a wire should be soldered to a terminal.
When soldering P/C board terminals, keep soldering time to within 5 s at 270°C soldering bath or within 3 s at 350°C soldering bath.
To clean the switch unit, use a neutral detergent diluted with water.
Do not use acidic or alkaline solvents as they may damage the switch.
Furthermore, be careful not to get any of the detergent solution inside of the switch while cleaning it.
Avoid using and storing these switches in a location where they will be exposed to corrosive gases, silicon, or high dust levels, all of which can have an adverse effect on the contacts.
Requests to customers (Automation Control Components & Industrial Device) [Excluding specific product]
Requests to customers (Automation Control Components & Industrial Device) [For specific product]
Requests to customers (FA Sensors & Components [Excluding motors])
Requests to customers (Dedicated to industrial motors)