CO2 Laser Marker LP-400

Three times the productivity means you save time and equipment.
Acceleration, deceleration and response speeds of the LP-400 series exceed those of previous models by at least 200 %. It is possible to mark on products that are moving rapidly. The LP-400 series that can mark 700 characters per second reduces tact time, leading to more than three times the productivity of previous models.
* Excluding 10 W type

Stability of laser output
With a laser output stability of within ± 3 % (typ.)*, 10.6 μm 0.417 mil wavelength models work well in applications ranging from marking thin films and other tricky substrates to processing tasks such as removing insulation from cables.
* Excluding 10 W type

Clear marking
Well-matched to the heat absorption characteristics of plastics, the 9.3 μm* 0.366 mil wavelength laser allows marking on plastic surfaces by melting the surface layer without creating excessively deep marking and limiting damage to the substrate. This capability rectifies issues with previous models where deep marking would create pinholes or otherwise make marking output difficult to read.
* LP-420S9 (20 W type)

High-quality processing
Short-wavelength laser radiation is readily absorbed by plastics, allowing the creation of sharp edges and increasing dimensional accuracy.

Space-saving design (tower head models)
At 175 x 230 mm 6.9 x 9.1 in, the tower head is smaller than a B5 sheet of paper. Tower head models require less space for installation and can be integrated into existing production line space.

Rotating head design (standard models)
A unique head design that rotates freely through 350° allows the laser marker to be installed even in a vertical orientation. Flexible installation options make it easy to fit the system into a variety of production environments.

A full line-up
A full line-up meets the needs of diversified production lines. Two types of laser wavelengths are available for tower head models and standard models. In addition, it is possible to select areas of 55 x 55 mm 2.2 x 2.2 in to 160 x 160 mm 6.3 x 6.3 in due to the three types of marking areas.

The LP-400 series come standard with application software for easily configuring print data. Marking layout can be easily performed as desired with intuitive and simple mouse operations. Moreover, batch control of multiple laser markers is possible using one computer. This significantly contributes to increased work efficiency.

The LP-400 series laser markers can be operated using a commercially-available monitor and mouse instead of console as equipped with the VGA connector and mouse connector.

■ USB connectors

The ability to store system settings on standard USB memory sticks lets you backup marking settings or copy the same set of settings to multiple laser markers, delivering improved ease of use compared to the floppy disk drive used by previous models.
(The system also supports USB-connected floppy disk drives.)

* Customers are encouraged to verify proper operation of system components in advance when using off-the-shelf hardware.