GSD File for Laser Marker's PROFINET Unit LP-ANW11

Information you need to know before using the software (Essential reading)

About GSD File for Laser Marker's PROFINET Unit LP-ANW11

Download the setup files (.zip) for PROFINET unit LP-ANW11 of the laser marker.
The zip file contains the following files:
- GSD file (in XML format): GSDML-V2.33-PIDSX-LMP-20xxxxxx.xml
- BMP file for GSD file: GSDML-0342-0001-SUNX-LMP-Device.bmp
- PROFINET Communication Guide: LP-RF_RV_PROFINET_CommunicationGuide.pdf

This GSD file can be used with the following laser marker models that has PROFINET unit LP-ANW11 attached.
- LP-RF series *1
- LP-RV series *1
*1: Produced in September 2019 or later and controller version 1.6.0 or higher.

Return to top

Caution

Be aware of the following points listed below.
This software is freeware. The copyright for this software is held by Panasonic Industrial Devices SUNX Co., Ltd. By using this software it is assumed that you agree to "Conditions of Use" presented below.

Conditions of Use

  • Panasonic Industrial Devices SUNX does not warrant anything regarding the use of this software.
  • Panasonic Industrial Devices SUNX will not assume responsibility of any sort for direct, indirect, repercussive, resulting or special damage that results from using this software or from the operation of the software itself.
  • Panasonic Industrial Devices SUNX does not restrict the use, copying or distribution of this software.
    However, when copying or distributing, Panasonic Industrial Devices SUNX prohibits the procurement of fees other than the cost of media, and prohibits the applying of restrictions in use of the software.

How to Install

1.Click on the title of the file name (listed below) that you want to download and indicate the download destination.

*When you already have indicated the download destination, the file will be downloaded automatically.

Title Language Version File size Update
lp-anw11_setup_profinet_v102.zip EN 3.3MB October 4, 2021

2.Decompress the downloaded file.

 

3.Install the GSD file to your PLC by following the instructions of the PLC.

 
 

Return to top