GM1 Firmware Detailed Version-Up Information

* Click here for GM Programmer Version-up Information

Version-up Information

Version-Up Information (Ver.1.3.0.3 to Ver. 1.4.0.0) (November 8, 2023 update)

The following points have been upgraded.

  • Expanded the maximum number of real axes for RTEX from 16 to 32 axes.
  • Added MQTT client.
  • Added DNS client.
  • Added SNTP client.
  • Added the project management function block.

■Corrected the following errors.

  • Fixed FTP server timestamp information to local time display.
  • Improved starting Controller if expansion units are connected.
    Fixed Digital input / output unit, Analog input / output unit and Pulse output unit too.

Version-Up Information (Ver.1.3.0.2 to Ver. 1.3.0.3) (June 21, 2023 update)

The following points have been upgraded.

■Corrected the following errors.

  • Starting Controller may fails only if expansion units are connected.

Version-Up Information (Ver.1.3.0.1 to Ver. 1.3.0.2) (February 1, 2023 update)

The following points have been upgraded.

■Corrected the following errors.

  • Fixed a bug in the CNC function.

Version-Up Information (Ver.1.3.0.0 to Ver. 1.3.0.1) (September 26, 2022 update)

The following points have been upgraded.

■Corrected the following errors.

  • The motion task stops during error clear processing.

Version-Up Information (Ver.1.2.0.0 to Ver. 1.3.0.0) (June 13, 2022 update)

The following points have been upgraded.

  • Added OPC UA server.
  • Added the comminication to display units. (Codesys V3 communication)
  • Added FTP server.
  • Added the project management. (SD backup and restore operating GM1 device directly)
  • Added the setting of whether to write the IP address.

Version-Up Information (Ver.1.0.1.0 to Ver. 1.2.0.0) (October 13, 2021 update)

The following points have been upgraded.

  • Added following models.
    - GM1 Controller EtherCAT type
    - Digital output Unit(PNP)
    - Digital I/O Unit (PNP)
    - Analog input Unit
    - Analog output Unit
    - Pulse output Unit
  • Supported firmware update by GM Programmer (USB/LAN).
  • The operation mode of GM1 Controller RTEX type can be changed to RUN mode regardless of the running status of the MINAS.

Return to top

 

Return to top