AUTOMATION
CONTROLS

Search
Discontinued
Products



Ultra-slim Photoelectric Sensor EX-10 Ver.2

Cautions For Use

  • Do not use this product for an application where it directly detects the human body. Otherwise, there is a risk of death or serious injury.
  • Do not use the EX-15□/EX-17□ for an application either where it directly detects the human body or where it indirectly protects the human body. Otherwise, there is a risk of death or serious injury.
  • When the human body needs to be detected for safety application, use products that conform to the laws and standards related to human body detection for safety application in each country, such as OSHA, ANSI, and IEC.
  • This product is not a safety sensor designed or intended to protect life and prevent bodily injury or property damage from dangerous parts of machinery.
  • This product conforms to the international standard ISO 13849-1 (Category 1, PLc) and can be used as a detection device to indirectly protect the human body.(Excluding EX-15 □ / EX-17 □)
  • When using this product as a part of the safety system, observe the precautions summarized in the "EX-10 series Users Manual" . The "EX-10 series Users Manual" explains important rules that must be observed to prevent personal injury and property damage when using the product as a part of the safety system. The "EX-10 series Users Manual" can be downloaded from the following website.

    >>Go to Data download.

Mounting

• In case of mounting on tapped holes (Unit: mm in)

In case of mounting on tapped holes (Unit: mm in)

The tightening torque should be 0.2 N·m or less.


• In case of using attached screws and nuts (Unit: mm in)

In case of using attached screws and nuts (Unit: mm in)

The tightening torque should be 0.2 N·m or less.

Operation mode switch

(EX-15□, EX-15E□, EX-17□ and EX-17E□ only)

Operation mode switch
Switch
position
Description
Light-ON mode is set when the switch is turned fully clockwise (L side).
Dark-ON mode is set when the switch is turned fully counterclockwise (D side).

Others

  • Do not use during the initial transient time (50 ms) after the power supply is switched on.
  • Excess bending of the cable or stress applied to the cable may disconnect the internal lead wire.

Return to top

CONTACT US
If you have any questions, please select the option below to contact us or find answers.
CONTACT BY EMAIL / PHONE FIND LOCAL OFFICE

Return to top

CONTACT US
BY EMAIL
Please click your area to select country or region




Requests to customers (Automation Control Components & Industrial Device) [Excluding specific product]
Requests to customers (Automation Control Components & Industrial Device) [For specific product]
Requests to customers (FA Sensors & Components [Excluding motors])
Requests to customers (Dedicated to industrial motors)