【Notification of Manufacturer Change for Panasonic Industrial Devices SUNX Products and Panasonic Industrial Devices SUNX Tatsuno Products】
From April 1, 2024, the terms "Panasonic Industrial Devices SUNX Co., Ltd." and "Panasonic Industrial Devices SUNX Tatsuno Co., Ltd."
in this page and in the manuals and other documents to be downloaded will all be replaced with "Panasonic Industry Co., Ltd." and applied accordingly.

AUTOMATION
CONTROLS

Search
Discontinued
Products



Compact Size Digital Pressure Sensor DP4 (Discontinued Products)

Specifications

Type Vacuum pressure Positive pressure Compound pressure
-101 kPa type 1 MPa type ±100 kPa type
NPN output PNP output NPN output PNP output NPN output PNP output
Model No. DP4-50 DP4-50P DP4-52 DP4-52P DP4-57 DP4-57P
Type of pressure Gauge pressure
Rated pressure range 0 to -101.3 kPa 0 to 1.000 MPa -100.0 to 100.0 kPa
Set pressure range 5.1 to -101.3 kPa
(0.052 to -1.033 kgf/cm2, 0.051 to -1.013 bar
0.74 to -14.70 psi, 38 to -760 mmHg
1.5 to -29.9 inHg)
-0.050 to 1.050 MPa
(-0.51 to 10.71 kgf/cm2
-0.50 to 10.50 bar
-7.2 to 152.2 psi)
-101.3 to 105.0 kPa
(-1.033 to 1.071 kgf/cm2
-1.013 to 1.050 bar
-14.68 to 15.22 psi)
Pressure withstandability 490 kPa 1.470 MPa 490 kPa
Applicable fluid Non-corrosive gas
Hysteresis 1 digit (however, variable in hysteresis mode)
Repeatability Within ±0.2 % F.S. ± 1 digit (within ±3 digits) Within ±0.2 % F.S. ± 2 digits
(within ±6 digits)
Supply voltage 12 to 24 V DC +10/-15 % Ripple P-P 10 % or less
Current consumption 40 mA or less
Output <NPN output type>
NPN open-collector transistor
・Maximum sink current: 100 mA
・Applied voltage: 30 V DC or less (between output and 0 V)
・Residual voltage: 1 V or less (at 100 mA sink current)
0.4 V or less (at 16 mA sink current)
 
<PNP output type>
PNP open-collector transistor
・Maximum source current: 100 mA
・Applied voltage: Same as supply voltage (between output and +V)
・Residual voltage: 2 V or less (at 100 mA source current)
  Utilization category DC-12 or DC-13
Output operation NO / NC (selectable by key operation)
Output modes Equipped with 4 types of modes: Hysteresis mode, window comparator mode, automatic sensitivity setting mode,
forced output mode (selectable by key operation)
Short-circuit protection Incorporated
Response time 2 ms, 16 ms, 128 ms, 512 ms or less (selectable by key operation)
Display 3 1/2 digit LCD display (with red and green backlight)
(Sampling rate: 256 ms, 512 ms, 1,024 ms selectable by key operation)
  Displayable pressure
range
5.1 to -101.3 kPa
(0.052 to -1.033 kgf/cm2, 0.051 to -1.013 bar
0.74 to -14.70 psi, 38 to -760 mmHg
1.5 to -29.9 inHg)
-0.050 to 1.050 MPa
(-0.51 to 10.71 kgf/cm2
-0.50 to 10.50 bar
-7.2 to 152.2 psi)
-101.3 to 105.0 kPa
(-1.033 to 1.071 kgf/cm2
-1.013 to 1.050 bar
-14.68 to 15.22 psi)
Analog bar display Bar display in steps of 14 % F.S. approx.
Operation display LCD segment is red when the output is ON, and green when the output is OFF
Pollution degree 3 (Industrial environment)
Protection IP40 (IEC) (Refer to p.1001 for datails of standards.)
Ambient temperature 0 to +50 ℃ +32 to +122 ℉ (No dew condensation),
Storage: -10 to +60 ℃ +14 to +140 ℉
Ambient humidity 35 to 85 % RH, Storage: 35 to 85 % RH
EMC EN 61000-6-2, EN 61000-6-4
Voltage withstandability 1,000 V AC for one min.
between all supply terminals connected together and enclosure
Insulation resistance 50 MΩ, or more,
with 500 V DC megger between all supply terminals connected together and enclosure
Vibration resistance 10 to 150 Hz frequency, 0.75 mm 0.030 in amplitude,
in X, Y and Z directions for two hours each
Shock resistance 100 m/s2 acceleration (10 G approx.) in X, Y and Z directions for three times each
Temperature characteristics Over ambient temperature range +10 to +40 ℃ +50 to +104 ℉
: within ±2 % F.S. of detected pressure at +25 ℃ +77 ℉
Over ambient temperature range 0 to +50 ℃ +32 to +122 ℉
: within ±5 % F.S. of detected pressure at +25 ℃ +77 ℉
Pressure port M5 female thread
Material Front case: ABS, LCD display: PET, Rear case: PBT [M5 threaded part: Brass (nickel plated)]
Connecting method Connector
Suitable cable Conductor cross-section area 0.16 to 0.32 mm2 (AWG#25 to #22) (Note 2)
Lead wire diameter ø1.2 to ø1.8 mm ø0.047 to ø0.071 in
Wire material Tin plated, soft, twisted copper wire
Cable length Total length up to 100 m 328.084 ft (less than 10 m 32.808 ft when conforming to CE marking) is possible with 0.3 mm2, or more, cable.
Weight Net weight: 30 g approx.
Accessories Panel mounting bracket (MS-DP-1): 1 set, Pressure unit label: 1 pc.
Connector: 1 set (Housing: 1 pc., Connector pin: 3 pcs.)

Notes:
1) Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +20 ℃ +68 .
2) If the wiring is longer than 5 m 16.404 ft, use a cable with a diameter of 0.3 mm2 or more.

Return to top

CONTACT US
If you have any questions, please select the option below to contact us or find answers.
CONTACT BY EMAIL / PHONE FIND LOCAL OFFICE

Return to top

CONTACT US
BY EMAIL
Please click your area to select country or region







BY PHONE

Requests to customers (Automation Control Components & Industrial Device) [Excluding specific product]
Requests to customers (Automation Control Components & Industrial Device) [For specific product]
Requests to customers (FA Sensors & Components [Excluding motors])
Requests to customers (Dedicated to industrial motors)