[Notification of CAD Data Download Issue]
We regret to inform you that we are currently experiencing issues with downloading CAD data for some products.
We are investigating the cause of this problem. We apologize for any inconvenience this may cause and appreciate your understanding.
【Notification of Manufacturer Change for Panasonic Industrial Devices SUNX Products and Panasonic Industrial Devices SUNX Tatsuno Products】
From April 1, 2024, the terms "Panasonic Industrial Devices SUNX Co., Ltd." and "Panasonic Industrial Devices SUNX Tatsuno Co., Ltd."
in this page and in the manuals and other documents to be downloaded will all be replaced with "Panasonic Industry Co., Ltd." and applied accordingly.
Business > Industrial Devices > Automation Controls Top > FA Sensors & Components > Sensors > Area Sensors > General Purpose & Slim Body Area Sensor NA2-N > Cautions For Use
Partly Order Discontinued
|
|
Job indicator input signal condition |
---|
Type | Signal | Signal condition |
---|---|---|
NPN output | Low | 0 to 2 V |
High | 5 to 30 V, or open (Note) | |
PNP output | Low | 0 to 2 V, or open (Note) |
High | 8 V to +V |
Note: | Insulate the wire if it is kept open. |
---|
(Purchase the screws and nuts separately.) |
Description | Function | |||
---|---|---|---|---|
Emitter | ① | Emission frequency selection switch | ||
② | Job indicator mode switch | |||
③ | ||||
④ | Job indicator / Test input (emission halt input) selection switch |
|||
⑤ | Job indicator (Red LED) |
Lights up, blinks or lights off when the job indicator input is applied, selected by operation mode switch. | ||
⑥ | Emitting indicator (Green LED × 2) |
Light up during emission; one LED lights up for Frequency A setting, both LEDs light up for Frequency B setting. | ||
Receiver | ⑦ | Job indicator (Red LED) |
Lights up, blinks or lights off when the job indicator input is applied, selected by operation mode switch. | |
⑧ | Stable incident beam indicator (Green LED) |
Lights up when all beam channels are stably received. | When an excess current flows through the output, the stable incident beam indicator and the operation indicator on the receiver blink simultaneously due to the operation of the short-circuit protection circuit. | |
⑨ | Operation indicator (Red LED) |
Lights up when one or more beam channels are interrupted. |
Note: | In order to use the job indicators as large operation indicators, make sure to set No. 4 of the operation mode switch to the OFF side. If it is set to the ON side, the job indicator does not light up or blink. |
---|
Operation mode switch setting |
---|
OFF | ON |
---|---|
Time chart |
---|
Notes:
1) | When the test input (emission halt) function is set, the job indicator (red) does not light up or blink. |
---|---|
2) | When emission is stopped during the test input (emission halt) function, the emitter’s emitting indicator (green) does not light up. |
Operation mode switch | Emitting indicator (Emitter) | |||
---|---|---|---|---|
Sensor Ⓐ |
|
|||
Sensor Ⓑ |
|
Place ferrite core at the sensor cable.
Prepare 2 pcs. of the following recommended ferrite core (or an equivalent product.)
[SEIWA ELECTRIC MFG. CO., LTD.] |
Requests to customers (Automation Control Components & Industrial Device) [Excluding specific product]
Requests to customers (Automation Control Components & Industrial Device) [For specific product]
Requests to customers (FA Sensors & Components [Excluding motors])
Requests to customers (Dedicated to industrial motors)