3.0mm x 2.0mm SMD (EVPAW, EVP6A)
1.DIMENSIONS
EVPAW
EVP6A
(Embossed Taping)
- External dimensions
-
General dimension tolerance : ± 0.05
( ) dimensions are reference dimensions. |
* | This reference specifications are subject to change. |
Part No. |
Operating Force |
Height |
Operating Life |
EVPAWBD40 |
1.6 N |
0.6 mm |
500,000 cycles |
EVPAWCD40 |
2.4 N |
0.6 mm |
500,000 cycles |
EVP6AWD40 |
3.0 N |
0.6 mm |
300,000 cycles |
EVPAWED40 |
3.3 N |
0.6 mm |
300,000 cycles |
|
|
- Circuit diagram
-
|
- PWB land pattern for reference
-
* | The thickness of the solder stencil shall be 0.1 mm, and the opening ratio of the solder stencil to a land pattern shall be 60 to 100 % (recommend 80 %.) |
* | Soldering failure may occur depending on applied solder amount, so, please consider to use our recommended stencil and land pattern design.
: Recommended land pattern area
: No soldering area
・Any land pattern or via holes shall not be provided at area.
・If it's necessary to design land pattern or via holes at area, please apply resist to them to protect their metal part completely.
・If their metal parts are not protected completely, short circuit failure may occur,
・Besides, there should be convexoconcave by designing additional pattern, it may cause switch tilt, influence on solder-ability or flux intrusion after reflow soldering.
・Therefore, please study any influence of additional land pattern or via holes at area in advance. |
|
Return to top
2.EMBOSSED TAPE DIMENSIONS
- Specifications for taping
-
Part No.: EVPAW, EVP6A
Height: 0.6 mm |
|
Return to top
Return to top